Configuring with Dash Design

GEMS Dash Design is the Windows application for configuring GEMS display modules, including the CD6. A Dash Design setup (.cd6.gdd) defines what the display does: its input channels, CAN messages, screens and gauges, alarms, LEDs, logging and outputs. You program a CD6 by uploading a setup to it. No programming is needed.

This page outlines the CD6 workflow and links to the GEMS Dash Design manual for details. Custom models are optional. They are covered in Adding a Custom Model to a Setup and Custom Models (CDX).

Install Dash Design

  1. Download GEMS DashDesign from the GEMS downloads page. Beta releases are listed under each product’s previous versions.
  2. Run the installer. See Installing GEMS Dash Design.
  3. Read Getting Started and Display Setup Concepts.

Use a Dash Design release that supports the CD6. For custom models, the release must also support CDX Model packages. The runtime’s revision history lists any minimum Dash Design version.

Configure a Setup

A typical CD6 setup is built in these steps. Each links to the relevant part of the Dash Design manual.

Step Where in Dash Design Dash Design manual
Create a setup for your CD6 type File menu Creating a New Display Setup, Opening and Saving Setups
Scale analogue inputs and define calculated channels Channels tab Channels Tab, Predefined Channels
Receive data from ECUs and transmit dash data on CAN CAN tabs CAN Message Overview, CAN Receive, CAN Transmit, DBC Import, CAN Bus Configuration
Design screens and gauges Design and Screens tabs Design Tab, Gauges, Screens Tab
Configure LEDs, outputs, logging and alarms Setup, Logger and Notifications tabs Setup Tab, Logger Tab, Notifications Tab
Check and simulate the setup Tools menu and Simulator tab Setup Checker, Simulator Tab
Program the display File > Upload To Display (F7) Uploading a Setup to a Display

The CD6 Hardware pages list the inputs, outputs and connector pins that the setup refers to.

Update Display Firmware

Dash Design also programs CD6 firmware, using Tools > Upload Firmware…. See Firmware Updates. The upload log shows the firmware version that a setup requires.

Custom models need CD6 firmware with model-runtime support. Obtain it from GEMS.

Adding a Custom Model to a Setup

A custom model is loaded into a CD6 setup and programmed with it. See Custom Models (CDX) for what models are for and how to build one. The Quickstart walks through these steps with the starter model.

On the Setup tab of an editable CD6 setup, the CDX Model panel manages the model:

  • Load CDX Model… imports a .cdxmodel package and replaces any current model and its IPC signals. Choose Embedded in setup to store the model firmware in the setup and program it with the setup. This is the normal choice. Independent on display keeps the firmware out of the setup, so you program it into the display separately.
  • On loading, Dash Design creates a channel for each signal the model sends (Receive From Model). It connects each signal the model receives to the existing numeric channel with the same name (Transmit To Model). Matching ignores letter case and treats spaces and punctuation as underscores, so the DBC signal Analogue_1 uses the channel Analogue 1. Loading fails, without changing the setup, if a name conflicts or a required channel is missing.
  • Reload loads a rebuilt package. Watch for updates reports when the package file changes on disk.
  • CDX Project Tools… builds a CDX project from Dash Design. See Build In Dash Design CDX Project Tools.

The model’s output channels work like any other channel. Show them on gauges, log them, use them in logic or transmit them on external CAN. Upload the setup as usual. Dash Design programs the embedded model firmware with it.

Automate Dash Design

Dash Design has command-line arguments and a COM automation API. The CDX CLI uses the API to embed models into setups and upload them. See Deploying to a display.