Getting Started

Working on tractive systems (which includes but is not limited to engine(s), motor(s), inverter(s), high voltage battery packs and high voltage cables) requires special experience and training.

Incorrect installation or use of GEMS Electronic Control units (ECUs) or software may lead to electrical / mechanical damage, injury or even death. As such, installation must only be performed by users with experience with electronic control systems and a competence of Windows based computer software.

All accompanying documentation must be read thoroughly before installation is attempted.

If you are in any doubts regarding the fitting and use of this product, please contact your reseller or GEMS directly at tech.support@gems.co.uk

General Engine Management Systems (GEMS) Ltd shall not be held responsible for any mechanical or electrical damage or personal injury occurring whilst using this product. Neither shall GEMS be held responsible for damage, injury or death caused by the misuse, misunderstanding or miscalibration of this product.

Installing Dash Design

Download and run the installer from https://gems.co.uk/downloads/software/. For more details, see Installing GEMS Dash Design .

Creating or Opening a Setup File

Create a new setup for your display type using File | New Setup..., or open an existing setup using File | Open Setup.... See Creating a New Display Setup and Opening and Saving Setups .

Channels

Channels may be configured to convert data acquired from CAN or analogue (A/D) inputs into physical units. See Channels Tab .

Logic channels can be used to generate logic outputs based upon comparisons of other channels. See Logic Channels Tab .

Channels may be chained together and have filtering applied.

More complex channel processing can be specified using Maths channels .

Gauges

Gauges generally are used to display the value(s) of input channel(s).

Gauges are configured on the Design Tab .

Verifying the Setup

The Setup Checker indicates warnings and errors in the setup file. It is best to resolve any warnings / errors before simulating or programming the display.

Simulating the Display

The setup can be tested on a simulated display via the Simulator Tab .

Programming the Display

The setup can be programmed into the display using the menu command File | Upload To Display F7. See Uploading a Setup to a Display .