Tacho Gauges

Overview

Gauge Icon Bar Tacho and Gauge Icon Round Tacho gauges are typically used with engine speed or road speed and are available as either a curved bar gauge or a round gauge. They use minimum, maximum and resolution in the same manner as bars but also have labeled segments, the frequency of which is specified by the label frequency property. The label values are divided by the label divisor property and then formatted.

See also Needle Gauge which can be used to draw a pointer over an image background.

Properties

In addition to Standard Gauge Properties , the following properties may be configured:

Property Description
Rectangular Tacho (Bar Tacho) Draw the tacho as a rectangle instead of an arc.
Smooth Edges (Bar Tacho) Draw smooth bar edges instead of stepped edges.
Separators Between Bars (Bar Tacho) Draw a separator in the line colour between bars instead of running them together.
Angle [degrees] (Round Tacho) Rotate the gauge by the specified angle.
Start Degrees (Round Tacho) The number of degrees from 6 o’clock (the zero degree position) at which the starting value of the gauge is drawn.
End Degrees (Round Tacho) The number of degrees from 6 o’clock (the zero degree position) at which the end value of the gauge is drawn.
Smooth Position On supported displays, interpolate the bar or needle position instead of snapping to the nearest segment.
Lower Limit Enabled (Bar Tacho) Draw the area below Lower Limit End in Lower Limit Colour.
Lower Limit End (Bar Tacho) Value where the lower limit area ends.
Lower Limit Colour (Bar Tacho) Colour of the lower limit area.
Upper Limit Enabled (Bar Tacho) Draw the area above Upper Limit Start in Upper Limit Colour.
Upper Limit Start (Bar Tacho) Value where the upper limit area starts.
Upper Limit Colour (Bar Tacho) Colour of the upper limit area.
Lower Limit Flash (Bar Tacho) Flash the lower limit area when the input falls below Lower Limit End.
Upper Limit Flash (Bar Tacho) Flash the upper limit area when the input rises above Upper Limit Start.
Flash All Enabled (Bar Tacho) Flash the entire gauge in Upper Limit Colour when the input exceeds Flash All Start.
Flash All Start (Bar Tacho) Value above which Flash All Enabled takes effect.
Flash Rate (Bar Tacho) Rate at which active flash modes flash, in milliseconds.

On supported displays (e.g. CD6), Round Tacho gauges also support background and fill gradients and the shared colour controller (see Colour Source in Standard Gauge Properties ). Round Tacho warning colours apply to the gauge background.

Note

When a Round Tacho gauge is rotated, or uses non-default start / end degrees, it is converted to a Needle Gauge with a generated background image when the setup is programmed into the display. This provides wider firmware compatibility.

Display Support

DisplaySupported?
CD34 Yes
LDS4 Yes
CD32 Yes
LDS35 Yes
LDS35_L Yes
CD6 Yes
GLW-43 Yes
LFRW-43 Yes
ZDU-L Yes
ZDU-P Yes