Bar Gauges
Overview
There are 4 types of bar gauge - rectangle and triangle shaped bars in either horizontal or vertical orientation:
Vertical Triangular
Horizontal Triangular
Vertical Rectangular
Horizontal Rectangular
Segments
A bar contains a number of segments that divide the bar up between the minimum and maximum limits.
Properties
In addition to Standard Gauge Properties , the following properties may be configured:
| Property | Description |
|---|---|
| Separators Between Bars | If checked, a separator line is drawn between each bar in the line colour. Otherwise, the bars run contiguously. |
| Fill From Centre | (Rectangular Bars) If checked, the bar is drawn from the centre. For example, consider a bar gauge with the minimum set to -2 and the maximum set to +2, with Fill From Centre checked. If the value of the input is -2, the bar will be filled from the midpoint (0) to the left hand side. If the input is 0, the bar will be unfilled. If the input is 2, the bar will be filled from the midpoint to the right hand side. |
| Single Line Mode | (Rectangular Bars) If checked, the bar is not filled; a single line moves across it to indicate the current value. |
| Square Mode | (Rectangular Bars) If checked, then the bar will not have a chamfer at one end. |
Rectangular bars also provide Corner Radius for rounded corners. On supported displays, Smooth Position interpolates the bar position between segments, while Flip X and Flip Y flip any bar variant horizontally or vertically.
Display Support
| Display | Supported? |
|---|---|
| CD34 | Yes |
| LDS4 | Yes |
| CD32 | Yes |
| LDS35 | Yes |
| LDS35_L | Yes |
| CD6 | Yes |
| GLW-43 | Yes |
| LFRW-43 | Yes |
| ZDU-L | Yes |
| ZDU-P | Yes |