Uploading a Setup to a Display

Overview

Uploading a setup programs the current setup into the Display Module.

Tip

View the Setup Checker to ensure there are no setup errors or warnings prior to programming the setup.

See Setup Checker

Display Module Selection

Ensure that the Display Module is attached to the PC. Ethernet based Display Modules may be attached directly to the PC with an ethernet cable or to a Local Area Network (LAN).

Display Modules that connect using USB should show a special screen once attached to the PC.

Select File | Upload To Display F7. A dialog will be shown to allow selection of the Display Module that should be programmed:

Upload Setup Dialog Upload Setup Dialog

Upload Setup Dialog

Select the Display Module to be programmed from the list. Typically there will only be one so the first item is selected by default.

Upload Original Setup

Depending upon the type of Display Module, there may be the option Upload original setup. When programming displays, the setup file is compiled into a more compact format that is understood by the display. If Upload Original Setup is checked, then the original setup file will also be programmed into the display to allow later recovery of the original setup used to program the display from the Display Module itself using the command File | Download From Display.

Starting the Programming Procedure

Click the Upload Upload button to begin programming the setup into the display.

If the setup’s display type does not match the connected display, a warning is shown. Choose Continue Anyway to upload the setup (it may not function correctly) or Cancel. Some display types do not allow a mismatched setup to be programmed.

If programming requires the logged data in the display to be erased, you are asked to confirm before continuing.

Programming Progress

The progress of the procedure will be shown, along with a log of messages:

Upload Setup Progress Upload Setup Progress

Upload Setup Progress

If the process fails, refer to the message log as it may identify the cause.

Firmware Compatibility

When programming, Dash Design checks the features used by the setup against the firmware version of the display. The firmware versions required by the setup are shown in the programming log, and warnings are shown if the setup uses features that the display firmware does not support. If the firmware version can’t be determined, these warnings are not shown.

Once the programming is complete, the Display Module may be disconnected from the PC. For USB connections, detaching the USB cable should cause the setup to run on the display.

Downloading the Original Setup

If the setup was programmed with Upload original setup checked, the original setup file can be recovered from the display using File | Download From Display.