GEMS - General Engine Management Systems Ltd - Forum

Hi there
I have a GEMS Plug in and play ecu fitted to a 95 WRX Impreza.How do wire the anti lag switch in.Any help much appreciated

Thanks

hi there, its all in the manual which you can down load form this site

hope this helps
mark

i have downloaded the manuals it doesnt show wiring dont suppose you have the link.darren

do you have a 4 or 3 plug ecu?

if its the 4 plug ecu then its the 2nd plug in from the right (smallest one) as you look as the ecu. you will see there is a top row and bottom row of wires. the one you want is on the bottom row and then its the 3rd wire in from the right. think its a green wire

hope this helps

Thanks very much for reply mate.Its the 4 pin type .So does that wire get cut and put a switch in between it

At the moment the engine is totally standard will it run ? Iam getting 440 injectors,uprated map sensor,upgraded fuel pump which came off the car the ecu did but there not coming until next week.

CheeRs

Had a look at the loom on my car today and pin B09 does not have a wire at it on my car loom iam told this is the pin for the anti lag switch.If i do run a wire from that pin does it just go to a switch and where does the other end go

Thanks

Hi there,

Yes it does, Run a wire from this pin to the live pin onj the switch. Then run your second wire from the ground pin on the switch to an earth on the car.

Hope this helps.

Ed