Hi Pete,

Thank you for your advice.

I tried them according to your advice, but failed in connection.
Therefore I sent my ECU by EMS to Ed today.
Please check my ECU.

Best Regards

Aki7

Hi, I bought GWv4 recently, but a PC cannot communicate with ECU. The same error occurs when I use USB-Serial convertor in a USB port or when I use a RS-232C cable in a COM1 port. Those errors are "Error: Rx Parity Framing Break", "Error: Rx Framing Break". My setting is "Baud:9600, Data: 8, Parity:...

Hi, I tried your advice. However, I was not able to adjust it to 3,000rpm. It becomes either 2,800rpm or 4,000rpm. Because it is very critical during 2,800rpm and 4,000rpm. Is this normal? Additionally, the ground of Crankshaft position sensor was connected to pin 4 (Analogue ground for sensors), bu...

Hi, Because my ZETEC engine is with carburetors, it is necessary to depress the throttle pedal before starting the engine. When I depress the throttle pedal a little, the tachometer shows a full scale promptly. Please explain to me your method for the calibration of the throttle position sensor. Bes...

Hello, The resistance value of the Crankshaft position sensor is about 400 ohm. And I will add an earthing point. When the engine off, I have another problem. The tachometer goes all the way up to full scale of 8,000 rpm when I depress the throttle pedal. Therefore I have to reset the peak value mem...

I have a MiniDLS (G1.16 & ZETEC ENGINE). However, the Rev. Limit of the engine is not constant. It changes between 7,000 rpm and 6,000 rpm. (The specifications of this engine seem to be 7,200 rpm) In the present situation, I cannot use the full performance of the engine. Because I want to improve th...